John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Disassemble and Inspect Rocker Arm Shaft Assembly 11. Remove all 26 cylinder head cap screws. NOTE: If cylinder head gasket failed, check and record each cylinder head cap screw torque before removing. Make a reference mark (in-line) on socket and cylinder head surface. Loosen cap screw at least 1/2 turn. Retighten cap screw (using torque wrench) until reference marks align, and record torque. RG5245 -UN-06DEC88 IMPORTANT: DO NOT use screwdrivers or pry bars between cylinder block and cylinder head to loosen head-to-block gasket seal. Lift cylinder head from block. If cylinder head sticks, use a soft hammer to tap the cylinder head. 05 12 12.

Remove cylinder head gasket. Inspect possible oil, coolant, or combustion chamber leaks. Also, check for evidence of incorrect or defective head gasket being used. NOTE: Do not rotate crankshaft with cylinder head removed unless all cylinder liners are secured with cap screws and large flat washers as described later in this group. S11,2005,MT -19-16AUG94 DISASSEMBLE AND INSPECT ROCKER ARM SHAFT ASSEMBLY NOTE: Make preliminary inspection during disassembly. Look for: —Worn or scored rocker arms, shaft, and shaft support. —Weak or broken springs —Lube oil restriction RG3801 -UN-23FEB89 1. Remove plugs (A) and washers (B) from ends of rocker arm shaft. 2.

Slide springs, rocker arms, and rocker arm supports off rocker arm shaft identifying their parts for reassembly in the same sequence they were in before disassembly. CTM42 (24MAR95) 05-12 6076 Diesel Engines—S.N. (500000— ) S11,2005,HY1 -19-07AUG91 160101 PN=55