Cylinder Head and Valves/Disassemble and Inspect Rocker Arm Shaft Assembly 3. Inspect rocker arm shaft (A) for severe scratching, scoring, or excessive wear at points of rocker arm contact. Measure rocker arm and shaft. Compare with specifications given below. NOTE: Wear could indicate weak valve springs, bent push rods, or loose rocker arm shaft clamps. RG3802 -UN-23FEB89 ROCKER ARM ASSEMBLY SPECIFICATIONS Rocker Arm I.D. . . . . . . . . . . 19.07—19.10 mm (0.7507—0.7520 in.) Rocker Arm Shaft O.D . . . . . . 19.01—19.05 mm (0.7484—0.7500 in.) 4. Check rocker arm adjusting nut (C) and screw (B) for damage. Visually inspect rocker arm for hairline cracks. Replace if necessary. IMPORTANT:
Be sure all oil holes in rocker arm shaft are clean and open. 05 13 5. Clean all rocker arm parts with clean solvent. Dry with compressed air. S11,2005,MB -19-28OCT92 6. Check for cups or concave wear (A) on ends of rocker arms where they contact wear caps. 7. Examine spacer springs on shaft between rocker arms. Be sure they are strong enough to exert a positive pressure on rocker arms. R26131 -UN-09DEC88 NOTE: If the rocker arm has been damaged by a valve failure, replace it and the push rods when replacing valves. 8. Roll rocker arm shaft and push rods on a flat surface to check for bends or distortion. Replace parts as necessary.
S11,0401,N -19-05FEB85 CTM42 (24MAR95) 05-13 6076 Diesel Engines—S.N. (500000— ) 160101 PN=56