John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Measure Valve Recess ASSEMBLE ROCKER ARM SHAFT ASSEMBLY 1. Assemble parts on rocker arm shaft opposite removal procedure. RG3801 -UN-23FEB89 Make sure rocker arm shaft end plugs (A) are firmly seated against end of shaft, and washers (B) are installed on shaft. S11,0401,O -19-08MAR94 MEASURE VALVE RECESS 1. Measure and record valve recess dimensions for all valves using JDG451 Gauge with D17526CI (English, in.) or D17527CI (Metric, mm) Dial Indicator or KJD10123 Gauge and compare measurements to specifications given below. 05 14 NOTE: Thoroughly clean all gasket material from cylinder head combustion face before measuring.

RG5250 -UN-06DEC88 VALVE RECESS SPECIFICATIONS Valve Recess Below Cylinder Head: Exhaust . . . . . . . . . . . . . . . . . . 1.19—1.70 mm (0.047—0.067 in.) —Maximum Recess . . . . . . . . . . . . . . . . . . . 2.46 mm (0.097 in.) Intake . . . . . . . . . . . . . . . . . . . 3.35—3.86 mm (0.132—0.152 in.) —Maximum Recess . . . . . . . . . . . . . . . . . . . 4.62 mm (0.182 in.) NOTE: If measurement does not meet specifications, check valve face angle and valve seat angle. If valve is recessed beyond the maximum specification, install either new valves, valve seat inserts, or both to obtain proper valve recess.

(See REMOVE VALVE SEAT INSERTS AND MEASURE BORES IN CYLINDER HEAD, later in this group.) RG,CTM42,G5,10 -19-28OCT92 CTM42 (24MAR95) 05-14 6076 Diesel Engines—S.N. (500000— ) 160101 PN=57