Cylinder Head and Valves/Inspect Valve Rotators and Wear Caps INSPECT AND MEASURE VALVE SPRINGS 1. Inspect valve springs for alignment, wear and damage. 2. Put springs on a flat surface to see that they are square and parallel. RG2732 -UN-23FEB89 T82054 -UN-08NOV88 3. Check valve spring tension using D01168AA Spring Compression Tester. NOTE: Free spring length of 65 mm (2.56 in.) springs differ slightly, but compressed height must be the same. VALVE SPRING SPECIFICATIONS Spring Load Height Intake: Open: 810—880 N (182—198 lb-force) . . . . . . . 38.1 mm (1.50 in.) Closed: 345—399 N (78—90 lb-force) . . . . . . . . 52.5 mm (2.07 in.) 05 17 Exhaust: Open: 797—867 N (179—195 lb-force) . . . . .
. . 38.5 mm (1.52 in.) Closed: 284—338 N (64—76 lb-force) . . . . . . . . 54.5 mm (2.15 in.) RG,CTM42,G5,11 -19-06SEP94 INSPECT VALVE ROTATORS AND WEAR CAPS 1. Insure that valve rotators (A), if equipped, will turn freely. Replace if defective. RG3491 -UN-23FEB89 2. Replace valve wear caps (B) if pitted or worn. 3. Inspect valve retainer locks for excessive wear. Replace as needed. S11,0401,T -19-14FEB95 CTM42 (24MAR95) 05-17 6076 Diesel Engines—S.N. (500000— ) 160101 PN=60