John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Head and Valves/Inspect and Measure Valves CLEAN VALVES 1. Hold each valve firmly against a soft wire wheel on a bench grinder. 2. Make sure all carbon is removed from valve head, face and unplated portion of stem. IMPORTANT: Any carbon left on the stem will affect alignment in valve refacer if valves need to be refaced. Do not use wire wheel on plated portion of valve stem. 05 18 S11,0401,U -19-13MAR92 INSPECT AND MEASURE VALVES 1. Thoroughly clean and inspect valves to help determine if they can be restored to a serviceable condition. Replace valves that are burned, cracked, eroded, or chipped. 2. Inspect valve retainer lock groove (C) on valve stem for damage.

Also inspect stems for signs of scuffing, which may indicate insufficient valve guide-to-valve stem clearance. Replace if defects are evident. 3. Measure valve head OD (A). Compare valve stem OD (B) with guide ID to determine clearance, as outlined later in this group. VALVE HEAD AND STEM SPECIFICATIONS A—Valve Head OD: Exhaust . . . . . . . . . . . . . . . . 46.87—47.13 mm (1.845—1.856 in.) Intake . . . . . . . . . . . . . . . . . . 50.87—51.13 mm (2.003—2.013 in.) RG5795 -UN-12AUG91 B—Valve Stem OD: Exhaust . . . . . . . . . . . . . . . . 9.44—9.46 mm (0.3717—0.3724 in.) Intake . . . . . . . . . . . . . . . . . .

9.46—9.49 mm (0.3724—0.3736 in.) RG,CTM42,G5,12 -19-03MAY93 CTM42 (24MAR95) 05-18 6076 Diesel Engines—S.N. (500000— ) 160101 PN=61