Cylinder Head and Valves/Inspect and Clean Cylinder Head 4. Use D05058ST Valve Inspection Center to determine if valves are out of round, bent or warped. VALVE FACE RUNOUT SPECIFICATION RG4234 -UN-23FEB89 Maximum permissible runout of valve face . . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) S11,2005,IZ -19-14FEB95 GRIND (REFACE) VALVES IMPORTANT: Valve grinding should only be done by experienced personnel familiar with equipment and capable of maintaining required specifications. RG5247 -UN-12AUG91 05 19 If necessary to reface valve, grind valve face to an angle of 29.25˚ ± 0.25˚ (A). IMPORTANT:
When valve faces are ground, it is important not to nick valve head-to-stem radius with facing stone. A nick could cause the valve to break. Radius all sharp edges after grinding. S11,2005,MG -19-20JUL94 INSPECT AND CLEAN CYLINDER HEAD Inspect all cylinder head passages for restrictions. Heads with restricted or clogged passages can be cleaned by soaking them in a tank of hot caustic solution. Scrape all old gasket material from head. Use a powered wire brush to clean sealing surfaces. If cylinder head is not put in a chemical hot tank for cleaning, clean with solvent and a brush. Dry with compressed air and be sure to blow out all passages. CTM42 (24MAR95) 05-19 6076 Diesel Engines—S.N.
(500000— ) S11,2005,KW -19-16AUG94 160101 PN=62