Cylinder Head and Valves/Torque-To-Yield Special Flanged-Head Cap Screws TORQUE-TO-YIELD FLANGED-HEAD CAP SCREWS—GRADE 180 MARKED “SPECIAL” RG4471 -UN-28FEB94 RG7139 -UN-01MAY94 Arrow (A) points toward front of engine. IMPORTANT: DO NOT use multi-viscosity oils to lubricate cap screws. 1. Lubricate cap screws with clean SAE30 engine oil and install in their proper locations as outlined previously. 2. Tighten cap screw No. 17 to 80 N·m (60 lb-ft). Sequentially (start at cap screw No. 1 and proceed through cap screw No. 26) tighten all cap screws to 80 N·m (60 lb-ft). 3.
Using an oil proof pen, pencil, or marker, draw a line parallel to the crankshaft across the entire top of each cap screw head. This line will be used as a reference mark. 05 36 IMPORTANT: If a cap screw is accidentally tightened more than 90˚ in any one sequence, DO NOT loosen cap screw but make adjustments in the next tightening sequence. 4. Sequentially (start at cap screw No. 1 and proceed through cap screw No. 26) turn each cap screw 90˚. Line on top of cap screw will be perpendicular to crankshaft. 5. Again, sequentially (start at cap screw No. 1 and proceed through cap screw No. 26) turn each cap screw 90˚. Line on top of cap screw will now be parallel to crankshaft. IMPORTANT:
Cap screws MUST NOT be tightened more than a total of 270˚ ±5˚. 6. Finally, sequentially (start at cap screw No. 1 and proceed through cap screw No. 26) turn each cap screw 90˚, SO THAT LINE ON TOP OF CAP SCREW IS AS CLOSE AS POSSIBLE TO BEING PERPENDICULAR TO THE CRANKSHAFT. It is not necessary to obtain the final turn in one swing of the wrench. TOTAL AMOUNT OF TURN FROM STEPS 4, 5, AND 6 IS 270˚ ±5˚. CTM42 (24MAR95) 05-36 6076 Diesel Engines—S.N. (500000— ) RG,CTM1,G5,4 -19-09AUG94 160101 PN=79