Komatsu — 21.2 TORQUE LIST

21. STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS 21.2 TORQUE LIST Unless otherwise specified, tighten the metric bolts and nuts to the torque shown in the table. The tightening torque is determined by the width across the flats @ of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Nm (newton meter):

INm + 0.1 kgm + 0.74 Ibft 0 0 Thread diameter Width across of bolt (mm) flat (mm) (a) (b) Nm km I Ibl=t 6 IO 8 13 10 17 12 19 14 22 13.2 + 1.4 31.4 + 2.9 65.7 zk 6.8 112 k 9.8 177+ 19 1.35 * 0.15 9.73 f 1.03 3.2 k 0.3 23.2 k 2.1 6.7 + 0.7 48.5 + 5.0 11.5 f 1.0 82.6 k 7.2 18.0 + 2.0 131 +14 16 24 18 27 20 30 22 32 24 36 279f 29 383+ 39 549 + 58 745 5 78 927+ 98 28.5 k 3 206 k 21 39f 3 282 f 29 56 _+ 6 405+ 43 76k 8 549 f 58 94.5 + IO 684+ 72 27 41 30 46 33 50 36 55 39 60 1320+ 140 1720+ 190 2210+ 240 275Ok 290 328Ok 340 135+15 973flOO 175 * 20 127Ok140 225 + 25 1630+180 280 k 30 2030 zk 210 335 * 35 2420 k 250 NOTICE When tightening panels or other parts having tightening fixtures made of plastic, be careful not to use excessive tightening torque:

doing so will damage the plastic parts. 3-l 5