24. SERVICE PROCEDURE NOTICE If small holes or thinner parts are found on the element when it is checked with an electric bulb after cleaning and drying, replace the element. When cleaning the element, do not hit it or beat it against something. Do not use an element whose folds or gasket or seal are damaged. 4. Set the cleaned element. 5. Cleaning or replacing for three outer elements should be carried out at the same time. Replacing inner element 1. First remove the outer element, and then remove the inner element. 2. To prevent dust from getting in, use a clean cloth or tape to cover the air connector (outlet side). 3.
Clean the air cleaner body interior, then remove the cover installed in Step 2. 4. Fit a new inner element to the connector and tighten it with nuts. Do not clean and reinstall a inner element. 5. Install the outer element and the cover. 6. After replacing the element, return the red piston in the dust indicator to its original position.