Komatsu — 24.2 WHEN REQUIRED

6. After several hours of running, retighten the nuts. REMARK The tightening operation is easier if the power wrench that has been supplied is used. When the nut is rusted and is removed by gas cutting, cut on both sides 8 of the nut as shown in the diagram. Be careful not to damage seat surface 0. If it is damaged, repair it. Be careful not to get spatter on the mounting surface. l Method of using power wrench The power wrench set is equipped with a special socket. This socket is designed so that it grips the nut and prevents the wrench set from coming pull out. This means that the tightening operation can be carried out by one worker.

This socket has a double construction, and is designed so that the outside can rotate 30”. It is used as follows. Cuttin or end arm 1. Align the hexagons of the inside socket and outside socket, then insert the nut that is to be tightened or loos- ened. 2. After inserting the nut, turn the outside socket 30” clock- wise. When this is done, the outside socket will catch the notch in the nut seat surface, and the wrench will not come off. socket 3. Put the reaction tighten or loosen. arm in contact with the blade rib, and 4. Turn the outside wrench. socket counterclockwise, and remove the 3-34