Komatsu — 24.4 EVERY 250 HOURS SERVICE

24. SERVICE PROCEDURE 24.4.2 CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE Prepare the following. l l Container to catch drained oil: Min 129 !2 capacity Refill capacity: 129 Q (34.1 US gal, 28.4 UK gal) Socket wrench, filter wrench. 0 1. Open cover 0 on the right side under the chassis, and take out hose 0. 2. Set a container to catch the oil under the drain valve. Loosen drain valve 0 slowly to avoid getting oil on your- self, and drain the oil. Take care not to loosen drain valve 0 so much that the stopper pin in the valve is distorted. Tightening torque drain valve @I: 64 f 15 Nm (6.5 f 1.5 kgm, 47 f 11 Ibft) 3.

Check the drained oil, and if there are excessive metal par- ticles of foreign material, please contact your Komatsu dis- tributor. 4. Fit the hose on the engine hook and tighten drain valve 0. 5. Using a filter wrench, remove full-flow filter cartridge 0 and by-pass filter cartridge 0 by turning it counterclock- wise. When doing this, to prevent getting oil on yourself, do not carry out this operation from immediately under the car- tridge. In particular, if this operation is carried out immediately after stopping the engine, a large amount of oil will come out, so wait for 10 minutes before starting the operation.

Clean the filter holder, fill a new cartridge with clean en- gine oil and coat the packing surface and thread of the new filter cartridge with engine oil (a thin coat of grease is also possible), then install the cartridge. 6. 3-47