Komatsu — 24.5 EVERY 500 HOURS SERVICE

24. SERVICE PROCEDURE 7. Loosen the knob of feed pump 0 and move the pump up and down to draw off fuel until air ceases to come out of plug 0. 8. Push in the knob of feed pump 0 and tighten it. REMARK When only replacing the filter cartridge, it is enough to bleed the air from the air bleeding plug at the filter head. However, if the fuel piping is removed, bleed the air also from the air bleeding valve of the injection pump. 24.5.2 REPLACE TRANSMISSION FILTER ELEMENT, TRANSMISSION LUBRICATING FILTER ELEMENT AND TORQUE CONVERTER OIL FILTER ELEMENT A WARNING Before opening the filter case, depress the brake pedal several times to release the pressure, then lock the brake pedal.

If there is still pressure inside the filter, the oil may spurt out. Open the floor cover in the middle of the machine. Remove bolts 0, cover 0, spring 0 and valve 0, then take out element 0. Clean the inside of the case and the removed parts, and install new elements. Replace the O-ring at the same time. After replacing the filter, loosen plug 8, and crank the en- gine to bleed the air. After bleeding the air, tighten plug 8 again. 3-55