24. SERVICE PROCEDURE 24.5.3 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL There is danger that the oil may spurt out under inter- to release the internal pressure before removing the The maintenance shall be made placing the machine on a horizontal plane. 1. After positioning oil filler plug 0 at the top by turning the final drive, remove it and check whether the oil in the final drive case is up to the lower edge of the plug hole. 2. If the oil level is still too low, add gear oil through plug hole 0 until the oil overflows. Before removing filler plug 0, remove all the mud and dirt from around oil filler plug 0. Be careful not to let any dirt or sand get in when adding oil.
For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. 3-56