24. SERVICE PROCEDURE 24.6 EVERY 1000 HOURS SERVICE Maintenance for every 250 and 500 hours should be car- ried out at the same time. 24.6.1 CHANGE OIL IN POWER TRAIN CASE, CLEAN STRAINERS (INCL. TRANS- MISSION CASE, TORQUE CONVERTER CASE AND BEVEL GEAR CASE) IA The oil is at high temperature immediately after the ma- chme has been operated. Walt for the 011 to cool down before starting the operation. Prepare the following. l Container to catch drained oil: Min 345 Q capacity l Refill capacity: 345 Q (91.1 US gal, 75.9 UK gal) 1. Remove the cover on the bottom of the rear body. 2. Remove drain plug 0 slowly to avoid getting oil on your- self, and loosen drain plug 0 to drain the oil. 3.
After draining, tighten drain plug 0 and install drain plug 0. 4. Open the inspection cover on rear floor, remove bolts @ and cover 0. 5. Take out strainer 0 and magnet 8. If any damage to strainer 0 or magnet 8 is found, re- place with a new one. 6. Remove all dirt from the strainer, then wash in clean light @ ? oil. Clean the inside of the case and the plug. 3-58