Komatsu — 12.12 OPERATING RIPPER

12. OPERATION 12.12.2 METHOD OF PIN-PULLER CONTROL 1. Stop the machine in a safe place, and lower the shank to the ground. Set the pin-puller control switch in the PULL OUT position to remove the mounting pin. Pull out 2. 3. Move the ripper desired position. up or down to set the shank to the surface of holder 1 St (Min.) F,,,165: 4. Set the pin-puller control switch in the PUSH IN position to insert the mounting pin. If the pin is not aligned with the hole in the shank, put the pin-puller control switch in the PUSH IN position and raise or lower the ripper slowly. REMARK When raising the pin position and digging deeply, use a long protector. This prevents wear of the shank. 2-65