12. OPERATION 12.13 ADJUSTMENT QF WORK EQUIPMENT When adjusting, it is dangerous if the work equipment IA WARN’NG is moved by mistake. Set the work equipment in a safe condition, then stop the engine and lock the work equipment securely with the safety lock. 12.13.1 BLADE ADJUSTMENT TILTING THE TILTDOZER NOTICE The maximum amount of tilt is 1380 mm (4.53 ft). (When the semi-U blade is used.) Be sure not to exceed 1380 mm (4.53 ft) for the tilt. The tiltdozer can be tilted by manipulating the blade con- trol lever as indicated below. Tilting adjustment to the right: 820 mm (2.7 ft) or more Tilting adjustment to the left:
820 mm (2.7 ft) or more (When the semi-U blade is used.) When a larger tilting adjustment is required, proceed as follows: By turning brace 0 with handle bar 0 secured to the L.H. brace, the blade can be tilted up to the max. adjustment of 1380 mm (4.53 ft) by changing the length of the brace (!2). Standard distance (c!) between joints is 1740 mm (5.7 ft). ADJUSTING SHIM IN BLADE CYLINDER CAP Set the standard shim adjustment in the blade cylinder cap to 4 mm (0.16 in). Remove shims to balance the wear of the cap and the ball at the end of the piston rod. The proper clearance to be maintained with the shims is 0.2 to 0.6 mm (0.008 to 0.024 in). Tt- 4 mm (0.16 in) 2-66