Komatsu — COOLANT

MAINTENANCE Percentage of Antifreeze Concentration by Volume Approximate Freezing Point Specific Gravity at 60°F (16°C) +32”F (OOC) 0 1 .ooo +2O”F (-71 C) 15 1.025 +lO”F ;:;o:; 25 1.040 0°F 33 1.053 -10°F -20” F E;:E; 40 1.062 45 1.070 -30” F 48 1.074 -40” F 53 1.080 -50” F 56 1.083 -60°F 59 1.088 -70” F t-;:q 62 1.092 -80” F 65 1.095 -90” F 67 1.097 -92” F 68 1.098 In tropical climates where antifreeze availability may be limited, use a corrosion inhibitor DCA4, to protect the engine cooling system. Inhibitors/Conditioners All cooling system inhibitors, including those in antifreeze solutions, become depleted through normal operation.

If the inhibitors in antifreeze are allowed to become depleted, the antifreeze becomes corrosive and attacks and coats the metallic surfaces of the cooling system which reduces heat transfer. Cooling system conditioners which contain these inhibitors must be added to maintain corrosion protection. 4. DCA4 is recommended to inhibit corrosion in the cooling system for the following reasons: l Improved compatibility with high silicate antifreezes to minimize hydro-gel formation if over concentration occurs. l Provides engine protection in the following areas:

- Solder corrosion/bloom - Copper corrosion/erosion/stress cracking - Oil fouling - Cylinder liner cavitation corrosion - Aluminum cavitation corrosion - Seal and gasket degradation SOLUBLE OIL IS NOT RECOMMENDED for use in this engine as its use will reduce heat transfer. There are no miracle additives that will increase heat transfer or prevent overheating. Conditioned water is still the best coolant. 3-14