Komatsu — RADIATOR CORE

MAINTENANCE TRANSMISSION OIL Carry out this procedure if there is any sign of oil on the transmission case, or if there is oil mixed with the cooling water. A WARNING! When checking the oil level, apply the parking brake, and lock the front and rear frames with the safety bar and pin. * After the engine is operated for 5 minutes, check the oil level of the transmission in neutral position at the engine low idling. 1. Start the engine and remove the cap of oil filler (F). L07DZ02t 2. Use the oil level gauge marked on dipstick to check the oil level. 3. The oil level should be between mark L and H, if necessary, add oil at the oil filler tube (F).

* The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS.” RADIATOR CORE Carry out this procedure if there is any mud or dirt stuck to the radiator and/or oil cooler. 1. Loosen the four mounting bolts (1) and remove radiator grille (2). 2. Clean the radiator core and oil cooler that are clogged with mud, dirt, etc., with compressed air. Steam or water may be used instead of compressed air. When cleaning the radiator core and oil cooler, choose a 2 mm (0.07 in) diameter nozzle (3) and use high pressure water at a pressure less than 40 kg/cm (569 psi / 3923 kPa).

* I 4 I!_ JI I I tii3bDOO7 * If it is impossible to remove all mud and dirt when cleaning from the radiator grille side of oil cooler (4), remove engine fan guard (6) and clean from the front side of radiator (5). * Hydraulic oil hoses should be checked at the same time. If a hose is found to have cracks or to be hardened by aging, replaced by new one. loosened hose clamps. such a hose should be Furthermore, check for w LO622007 r 3-27