MAINTENANCE CLEANING OUTER ELEMENT Using compressed air A WARNING! Do not clean or replace the air cleaner element with the engine running. A WARNING! When using compressed air, wear safety glasses and other things required to maintain safety. Direct dry compressed air, less than 7 kg/cm2 (100 PSI / 639 KpA), to element from inside along its folds, then direct it from outside along its folds and again from inside. Check element as follows. LlPAVOl4 Using water NOTICE: The following method requires a spare element. Wash the element with city water at less then 3 kg/cm2 (43 psi / 296 kPa) of pressure, from the inside along the folds, then from the outside and again from the inside.
Dry the element and check !t as fo!lows. Using water with cleaning agent NOTICE: The following method requires a spare element. For removing oil and grease as carbon etc. on the element, the element may be cleaned in a lukewarm solution of mild detergent, then rinsed in clean water and left to air dry. * Using warm water at about 40” C (104” F) instead of soapy water may also be effective. * The drying process can be speeded up by applyinr dry compressed air, at less than 7 kg/cm (100 PSI / 689 KpA), to the element from the inside to the outside of the element. NOTICE: Never attempt to heat the element.
LlZAVOX * If small holes or thinner parts are found on element when !t is checked with an electric bulb after cleaning and drying, replace the element. * Do not use element whose folds or gasket or seal are damaged. * If element is usable, wrap it and store it in dry place. f When cleaning element, do not hit it or beat it against something. 3-26