Komatsu — ADJUSTMENT

MAINTENANCE PARKING BRAKE INSPECTION If 12 or more ratchets are counted before the parking brake comes into effect, perform the following adjustment. ADJUSTMENT 1. Move lever (1) back fully to release caliper (5). 2. Loosen lock nut (2) and remove clevis pin (4). 3. Adjust with adjustment bolt (7) so that clearances (A) and (B) between the disc and pad are 0.05 - 0.2 mm. 4. Push up by an amount equal to clearance of the caliper lever, and screw in clevis (3). Align the pin hole of caliper lever (6) then assemble clevis pin (4) and tighten locknut (2). * Don’t tighten adjusting bolt (7) too much. * After adjusting, make sure that there is no play of adjustment bolt (7) in the axial direction.

After adjustment, check the stroke when the lever is pulled (approx. 5 kg) three or four clicks from released position. A * WARNING! Install blocking in front of and behind the wheels before adjusting the parking brake. 7mm NOTICE: When the thickness (including lining) of a pad wears out to 7 mm or less, replace the pad. * Replace two pads as one set, and replace the retraction plate (8) at the same time. * Have the pads replaced by your distributor. A WARNINGI Do not get any oil or grease on the surface of the brake pad or disc. 3-33