MAINTENANCE CHECK BEFORE STARTING See the section on CHECK BEFORE STARTING aforementioned in SECTION 2. EVERY 50 HOURS SERVICE FUEL TANK Loosen valve (1) on the bottom of the tank so that the precipitation and mixed water will be drained in accompaniment with fuel. TIRES Measure the inflation pressure before operations when the tires are cool. Refer to HANDLING TIRES. Also, at this time, check for tire damage. EVERY 100 HOURS SERVICE * Maintenance for every 50 hours should be carried out at the same time. HYDRAULIC TANK Lower the bucket horizontally to the ground and stop the engine. Wait for 5 minutes, then check sight gauge (G). The oil should be visible in sight gauge (G).
Add engine oil at the oil filler (F), if necessary. A * * WARNING! When removing the cap, turn it slowly to relieve inner pressure. Turn wrench clockwise and hold it, then remove the filler cap by turning it counter- clockwise. I L10BV046 1 The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS.” 3-34