MAINTENANCE 3. Using a filter wrench, remove the fuel filters by turning them counterclockwise. Discard the filters in a suitable manner if they are not needed for any reason. 4. Clean the filter gasket surfaces of the filter header for each filter. Replace the filter O-rings. 5. Fill the new filters with clean diesel fuel. Then, apply a thin coat of clean engine oil to the seal of the filter. &J &lj LIZBMOO! 6. Install the filters on the filter header until the filter seal contacts the seal surface of the filter header and then, turn the filter an additional l/2 to 3/4 turn by hand. 1 2 * Do not over tighten the filter or damage may result to the filter seal or threads.
Use a genuine filter. * 7. After replacing the filters, start the engine and idle it for a few minutes. Check the filters for possible fuel leakage. 8. Close the engine side access cover. 3-44