MAINTENANCE TRANSMISSION OIL FILTER 1. Remove drain plug (1) at the bottom of the filter case, and drain the oil. After draining the oil, tighten the plug. 2. Hold case (2) and loosen center bolt (3), then remove case (2). * Be sure to use a genuine filter element. * Replace the filter gasket and O-rings with new parts. Coat the gasket and O-rings with clean engine oil before installing. 3. Remove the element, and clean the inside of the case. Assemble a new element, then install the case. * Before tightening center bolt (3), install bolt washer (4) so that its chamfered surfaces faces the hexagonal head of the center bolt. * Be careful not to apply excessive torque to center bolt (3).
j, Torque center bolt (3). Tightening torque: 7.8 r 1.2 kgm. 4. Run the engine for a short time at idling speed, then stop the engine. Check that the oil is at the specified level (for details, see WHEN REQUIRED). L07BVOOt ANTIFREEZE CONCENTRATION Check the antifreeze concentration. Use ethylene- glycol base antifreeze to protect the engine to -37°C year round. See SECTION 2. 3-45