Komatsu — HYDRAULIC TANK AND FILTER

MAINTENANCE HYDRAULIC TANK AND FILTER 1. Lower the bucket horizontally to the ground and apply the parking brake, then stop the engine. 2. Remove the cap of oil filler (F). * Turn wrench clockwise and hold it, then remove the filler cap by turning it counter- clockwise. A WARNING! When removing the cap, turn it slowly to relieve inner pressure. 3. Loosen drain plug (1) to drain oil. After draining, tighten the drain plug. A WARNING! The filter cover is pushed up by spring tension, so hold the cover down when removing the bolts. 4. Remove the mounting bolt of filter cover (2), then remove the cover. Remove spring (3) and bypass valve (4), then remove element (5). 5.

* Check that there is no foreign matter inside the tank before cleaning it. 6. Install a new element, then install (4), spring (3), and cover (2). bypass valve * If the o-ring of the cover is damaged or deteriorated, replace it with a new pan. * When installing the cover bolts, push down the cover and tighten the bolts evenly. 7. Pour the specified quantity of engine oil from filler (F). 8. Bleed the air from the hydraulic circuit, lower the bucket horizontally to the ground, and stop the engine. See “BLEEDING AIR FROM CIRCUIT” for the air bleeding procedure. 9. Check the oil level and ensure that is correct. (Refer to EVERY 100 HOURS SERVICE.) * Refill capacity:

38 P * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. * Check that there is no oil leaking from the filter cover mount. 3-48