MAINTENANCE DRIVE BELT 1. Measure the belt deflection at the longest span of the belt when pressed with the finger. * Cummins belt tension gauge ST-1 293 may be used. The required gauge value is 36 to 50 kg. Maximum deflection: 9.5 - 12.7 mm DRIVE BELT, TENSIONER BEARING AND FAN HUB 1. Remove drive belt (1) and complete the following steps: 2. Inspect the belt for damage. 3. Check the tensioner bearing. -k The tensioner pulley should spin freely with no rough spots detected under hand pressure. 4. Check the fan hub bearing.