MAINTENANCE 6. After flushing with water, stop the engine. Close drain valve (2) and drain plug (3) after draining water. 7. After draining water, clean with a flushing agent. * If the system shows mineral build-up, scale, rust or oil, use a heavy duty radiator cleaner and follow the manufacturer’s direction. * Do NOT use caustic cleaners in the cooling system. Aluminum components will be damaged. I LO6AM034 * Follow the instructions on the label of the flushing agent used to clean the system. After cleaning the cooling system, again flush the system with soft water until clean water flows out of the drain openings. Then close drain valve (2) and plug (3), and pour in soft water (ex:
city water) up to the vicinity of the water filler. When the water reaches the vicinity of the water filler, put the engine at low idling, open drain valve (2) and plug (3), then pass water through the cooling system until clean water comes out from drain valve (2) and plug (3). * When doing this, adjust the inflow and oufflow of water so that the radiator is always full. IO. When the water becomes completely clean, stop the engine, drain water and close drain valve (2) and plug (3). f During filling, air must be vented from the engine coolant passage. Adequate venting is provided for a fill rate of 30 liters/minute. 11.
Fill the cooling system with the correct mixture of water, antifreeze and the correct amount of DCA4. 12. Run the engine for 5 minutes at low idling to eliminate air trapped in the cooling system, and run the engine for 5 minutes at high idling. (leave water filler cap (1) off during this operation.) 13. Stop the engine and 3 minutes later supply the system with the correct mixture of water, antifreeze and the correct amount of DCA4 up to the bottom of the radiator filler opening. 14. Repeat Steps 12 and 13 to ensure that the coolant mixture is up to the bottom of the radiator filler opening. Install and tighten the radiator cap. 3-58