Komatsu — CAB DOOR HOLD OPEN LOCK - IF EQUIPPED

OPERATION 9. WORK EQUIPMENT CONTROL LEVER LOCK This is used to lock the work equipment control lever. A WARNING! When parking or leaving the machine, or when performing maintenance, always lower the bucket to the ground, put the work equipment levers in hold position and check that the safety lock lever is locked. I LlOAZ057 10. PARKING BRAKE LEVER This lever operates the parking brake. The brake is applied by pulling this lever, and the parking brake pilot lamp lights up. Push the button on the tip of the lever to release the parking brake. A * WARNING! Always apply the parking brake when leaving the machine or parking it.

The machine does not start when the directional lever is operated with the parking brake applied. CAB DOOR HOLD OPEN LOCK - IF EQUIPPED This lock can be used to hold the cab door open. Open the door so that tip (2) of the lever is aligned with groove (1) for the lock, then pull down knob (3) as shown in the diagram. When releasing the lock and closing the door, push up knob (3) and insert pin (4) securely in the groove. j, When using the hold open lock, be sure to apply the lock securely. 2-16