Komatsu — AIR INTAKE SELECTOR LEVER

OPERATION CAB HEATER AND DEFROSTER - IF EQUIPPED CONTROL PANEL It is possible to use the cab heater to good effect in dusty jobsites. The outside air is passed through the filter and is sent to the operator’s cab to increase the pressure inside the cab. In this way, dust is prevented from entering, so comfortable operating conditions are always maintained for the operator. 1. FAN SPEED SWITCH (1) This switch controls the air flow when the cab heater is used for heating. It has three air flow control levels: LO (Low), ME (Medium) and HI (High) 1 Ll3EZOl; * * If the outside air is extremely dusty, set the fan speed switch to the HI position.

This will pressurize the cab and prevent the dust from entering. 2. FOOT / DEFROSTER SELECT LEVER (2) This lever is used to control the air flow to the foot and defroster vents. 3. AIR INTAKE SELECTOR LEVER (3) This lever switches the air intake port when heating. * FRESH: Operate the lever to the right. Fresh air is taken in from outside in addition to the air inside the compartment. This is used for ordinary heating and when pressurizing the inside of the cab. * RECIRC: Operate the lever to the left. Only the air inside the compartment is used. This is mainly used for quick heating.

1= Lock 2= Free * The effectiveness of the heating system can be increased by selecting the most suitable vent. * Do not turn the fan speed switch on when all the vents are closed. 2-25