OPERATION CHECK BEFORE STARTING Pre-operation checks forestall machine trouble. Never neglect them. WALK-AROUND CHECK Look around the machine and under the machine to check for loose nut or bolts, collection of dirt, or leakage of oil, fuel, or coolant, and check the condition of the work equipment and hydraulic system. Check also for loose wiring, play, and collection of dust at places which reach high temperatures. 1. Check wear of bucket. Check around transmission case joints for oil 2. 3. Check around brake system for oil leak. leak. 4. Check tightness of air cleaner mounting bolt. 5. 6. 7. Check radiator for water leak. Check around the engine for water and oil leaks.
Check tightness of battery terminal. 8. 9. 10. Check around axle for oil leak. Check hydraulic tank joint for oil leak. Check for oil leak at high pressure hose and high pressure hose joints. 11. Check tire for wear and damage. CHECK AND REFILL COOLANT 1. Open left engine side cover. 2. Check the level of the coolant. The water level must be between the FULL (A) and LOW (B) marks on sub-tank (1). 3. If the level is too low, add water to sub-tank (1). A WARNING! Do not open the radiator cap unless necessary. Check always the coolant level of the sub-tank when engine is cold. * If the volume of coolant added is more than usual, check for possible water leakage.
* Confirm that any oil is not in coolant. * Use a mixture of 50% water and 50% ethylene glycol base antifreeze. 2-26