OPERATION A WARNING! If this operation is carried out * when the oil temperature is still low, even when the steering wheel is turned and stopped, there may be a time lag before the chassis turns or stops. In such cases, carry out the warming-up operation in a * large open area. In addition, use the safety bar to ensure safety. In this case, do not relieve the circuit for more than 5 seconds. Turn the steering wheel a short distance, then stop it, and check that the chassis stops according to the amount the steering wheel is turned. The recommended oil for the work equipment hydraulic system depends on the ambient temperature. Select oil according to the table under “LUBRICANTS.
FUEL AND COOLANT” in Section 3. 4. Turn the steering wheel slowly to the left and right to warm up the oil inside the steering valve. Repeat this operation about 10 times. MOVING MACHINE OFF 1. Check that the caution lamps are not lighted. 2. Free the safety lock (1) for work equipment control lever. Bring the work equipment in the traveling posture. 3. Depress right brake pedal, and move parking brake lever (2) to OFF (release) position to release the parking brake. 4. Set speed control lever (3) and directional lever (4) to the desired position. 5. Release right brake pedal, then depress accelerator pedal to move the machine off. A WARNING!
If the machine has to be started on a slope, always turn the trans- mission cut-off selector switch to OFF and depress the left brake pedal. Then depress the accelerator pedal while releasing the left brake pedal to start the machine off slowly. 2-35