Komatsu — COLD WEATHER WARM-UP PROCEDURE

OPERATION CHECKS AFTER STARTING After starting make the following checks. 1. Depress accelerator pedal (1) lightly and run the engine with no load at mid-range speed for about 5 minutes. 2. After warm-up run is completed, check monitor lamps for proper operation. * Continue to run the engine at light load until the green ranges of the engine water temperature gauge and torque converter oil gauge are indicated. 3. Check if the exhaust color is normal or whether there is any abnormal noise or vibration. * Avoid abruptly accelerating the engine until the completion of warm-up. Do not run the engine at low idle continuously for more than IO minutes.

* COLD WEATHER WARM-UP PROCEDURE When starting the engine the engine in cold weather, do not start operations immediately. First carry out the following. gradually increase the amount you move the lift cylinders. 4) Repeat Steps 1) - 3) for the bucket control lever to warm up the work equipment circuit. Ambient temperature Warm-up time * Run the engine with the throttle at the l/3 position or below.

-20” C (-4” F) 15 minutes -10°C (14°F) 10 minutes 0°C (32°F) 5 minutes 5) Raise the bucket 10 - 30 cm (3.7 - 11.8 in) from the ground, operate the bucket control lever to the tilt position, relieve the circuit for approximately 5 seconds, then return the lever to the neutral position and hold it for approximately 2 seconds. Repeat this operation to warm up the work equipment circuit. * Avoid sudden acceleration of the engine before the warming-up operation is completed. * Do not idle the engine continuously for more than 20 minutes. Ir ;;aissdthe engine speed gradually from the idling 2. After completing the warming-up operation for the engine, warm up the work equipment circuits.

1) Move the lift arm control lever slowly to the RAISE position and raise the bucket slightly. a WARNING! if the machine is operated suddenly before the warming-up operation is carried out, the work equipment may be damaged. The warming-up operation is also mandatory for safety reasons. 2) Move the lift arm control lever slowly to the LOWER position and lower the bucket slightly. 3. Warm up the steering circuit as follows. 3) Repeat the above operation several times and 2-34