Komatsu — COLD WEATHER STARTING

OPERATION 3. When the engine starts, release the key of starting switch (l), and the key will return automatically to the ON position. * Do not leave the key in START for more than 20 seconds. * If the engine does not start, repeat the starting procedure after about 2 minutes. A = OFF B = ON C = START A WARNING! Never operate the ether start switch (2) except when starting the engine. * Remove the ether cylinder when it is unnecessary in summer. * The ether cylinder can be used for about 230 times. (Amount of ether injected: 3 cc, total capacity for one cylinder: 710 cc.) A * When ambient temperature is below -25”C, keep the ether cylinder in a place where the temperature is normal. WARNING!

Carefully handle the ether cylinder. * Before changing the ether cylinder always clean out the valve area where cylinder is installed, and replace the gasket at the same time. 0 Never give cylinder access to fire. * The standard specification machine is designed to work in an ambient temperature down to -20” C (- 4°F). 0 After used, do not throw it in fire nor drill a hole in it. l Do not store it at places where the temperature may rise over 40°C. * When operating the machine at temperatures below -2O”C, special equipment is needed. Contact your distributor for details. l Never put ether gas on the skin nor breath it in.

* For machines where the air dryer is installed as an option, in cold temperatures below -10°C (+ 14”F), after the machine has been stopped, operate the machine for at least 10 minutes after starting before moving the machine. l Do not leave it on the operator’s seat. l Do not leave it at places where children can reach or play with it. l NEVER use ether together with a preheating device for the air intake. 2-33