Komatsu — IF ENGINE STOPS

OPERATION IF WHEEL BRAKE DOES NOT WORK If the machine is not stopped by depressing brake pedal, use the parking brake to stop the machine. PRECAUTIONS WHEN DRIVING UP OR DOWN SLOPES LOWER THE CENTER OF GRAVITY WHEN TURNING When turning on slopes, lower the work equipment to lower the center of gravity before turning. It is dangerous to turn the machine with the work equipment raised. If it overheats, place the speed control lever in the next lower gear speed to lower the oil temperature.

If the temperature gauge does not indicate the green range of the scale even with the lever in the 1st speed position, stop the machine, place the lever in neutral, and run the engine at medium speed until the gauge indicates the green range. BRAKING ON DOWNHILL SLOPES When going down slopes, put the speed control lever in a low gear position (the same position as when driving up the slope). Make full use of the engine to slow the machine, and use only the right brake pedal. IF ENGINE STOPS If the engine stops on a slope, depress the right brake pedal fully. Next, lower the work equipment to the ground and apply the parking brake.

Then put the directional and speed control levers in neutral, and start the engine again. (If the directional lever is not in neutral, the engine will not start). If the speed control lever is not placed in a proper speed position, the torque converter oil may overheat. 2-41