OPERATION OPERATIONAL PRECAUTIONS WORKING IN DUSTY LOCATIONS 1. Inspect the dust indicator to se whether the air cleaner is blocked up. Clean the air cleaner as soon as it becomes dirty. l When welding, be careful of the following: 1) Turn OFF the power (starting switch). 2. Clean the radiator core so that it does not become blocked up. 2) Do not continuously apply more than 200 V. 3) Install the ground cable at least 1 m from the range to be welded. 3. Clean or replace the fuel filter as soon as it becomes dirty. 4. Clean the electrical equipment, particularly the starting motor and alternator, to prevent the accumulation of dust.
4) Take care not to install the seals between the grounded point and the range to be welded. * Use ordinary automobile washer fluid. Be careful not to let dirt or dust get in. l When installing a car radio and a walkie-talkie or citizen band, contact your distributor. GREASING THE ROD END 0 When washing the machine, take care not to splash water over the electrical equipment. If it is soaked with water, it may not operate normally. Because the rod end is of the oilless type, no greasing is required, although a grease nipple is fitted to the rod end of the lever linkage. 0 After disconnecting a connector, cover it with a vinyl bag to prevent oil or dust from sticking to its contact section.
The rod end should be greased only when it becomes stiff after using it for a long span of time. MAXIMUM DEPTH OF WATER When working in water or on swampy ground, do not let the water come above the bottom of the axle housing. * After finishing the operation, wash and check the lubricating points. * L07FM03f 1 = Axle housing 2-40