Komatsu — TIRE PRESSURE

OPERATION HANDLING TIRES PRECAUTIONS WHEN HANDLING TIRES If the following defects are found in tires, for safety reasons the tire should be replaced with a new tire. Bead wire is broken or bent, or the tire is greatly deformed. Wear is excessive and the carcass ply (excluding breaker) is exposed for more than l/4 of the circumference. Damage to the carcass exceeds i/3 of the tire width. L15AR02 Tire layers are separated. 1 = Sidewalls 2 = Tread 3 = Breakers 4 = Carcass 5 = Beads Radial cracks reach the carcass. Deformation or damage which makes the tire unsuitable for use.

PRECAUTIONS WHEN DRIVING MACHINE When the machine travels at high speed for a long distance, the tires become extremely hot. This causes early wear of the tires, so it should be avoided as far as possible. If the machine must be driven for a long distance, take the following precautions. 0 Tire pressure: Front 2.8 kg/cm2 Speed: 25 to 30 km/h (16 to 18 MPH) Check the tire pressure before starting, when the tire is cool. l Follow the regulations related to this machine, and drive carefully. 0 After traveling for 1 hour, stop for 30 minutes. Check the tires and other parts for damage; also check the oil and coolant levels.

l The most suitable tire pressure, travel speed, or tire type differ according to the condition of the travel surface. Contact your distributor or tire 0 dealer for information. 0 o The following is a guide to suitable tire pressures and speeds when traveling on a paved surface with standard tires. Always travel with the bucket empty. Never put calcium chloride or dry ballast in the tires when traveling. TIRE PRESSURE Measure the tire pressure before starting operations, when the tires are cool. tire may be cut or may burst under shock. Therefore adjust the inflation pressure to the values in the following table.

If the inflation pressure is too low, it causes overload on the tires; if the inflation pressure is too high, the 2-50