OPERATION TROUBLESHOOTING This guide is not intended to cover all conditions, however many of the more common possibilities are listed. l In cases of abnormalities or causes which are not listed below, contact your distributor. ELECTRICAL SYSTEM Lamp does not glow brightly even when engine runs at high speed. The ‘cranking motor disengages before the engine starts up 0 Check and repair the wiring. l Check for loose terminals and open-circuit wiring. Lamp flickers while engine runs. l Charge the batteries. l Adjust belt tension. The engine pre-heating monitor does not flash. 0 Check and repair wiring. 0 Replace the heater relay. 0 Replace the monitor.
Charge monitor does not go out even when engine runs at high speed. l Repair or place the alternator. l Inspect and repair wiring. The engine oil pressure monitor does not light up when engine is stationary and when the starting switch is in ON position. 0 Replace the monitor. 0 Replace the monitor sensor. 0 Inspect and repair the wiring. Unusual noise is emitted from the alternator. l Repair or replace the alternator. Cranking motor does not turn when starting switch is turned on. l Inspect and repair the wiring. Charge monitor does not light up when the engine is stationary and when the starting switch is in ON position. 0 Replace the monitor. 0 Inspect and repair the wiring.
l Charge the batteries. The pinion of the cranking motor keeps going in and out. l Charge the batteries. Outside the electrical intake air heater is not warm when touched with the hand. Cranking motor turns the engine sluggishly. l Charge the batteries. l Check and repair wiring. 0 Replace the electrical intake air heater. 0 Check and repair the heater switch. l Replace the cranking motor. ENGINE The engine oil pressure monitor flashes when engine speed is raised after completion of warm-up. if it has a faulty gasket. l Replace the monitor. l Replace the oil filters. l Add the oil to the specified level. The engine does not start when the cranking motor is turned over.
l Check oil leakage from the pipe or the joint. l Replace the monitor. l Add fuel. l Repair where air is leaking into fuel system. Steam is emitted from the top of the radiator at the pressure valve. The engine coolant temperature monitor flashes. l Replace the injection pump or the nozzle. l Check engine valve clearance. l Check engine compression pressure. l Refer to section for ELECTRICAL SYSTEM. l Supply the coolant and check for leakage. l Adjust fan belt tension. Exhaust gas is white or blue. l Clean or repair radiator core fins. l Clean and flush inside of cooling system. l Adjust to specified oil quantity. l Replace with specified fuel. l Replace engine thermostat.
l Tighten the radiator cap firmly or replace the cap 2-57