OPERATION CONNECTING BOOSTER CABLES Connect the booster cables in the following manner. A WARNING! When connecting the cables, never contact the positive (+) and negative (-) terminals. A WARNING! Make sure that the booster cable connections are correct. Connect the booster cable to the enaine block as far as “I” = Engine block of problem machine “II” = Booster batteries “Ill” = Batteries of problem machine possible from the battery. 1. Connect one clamp of booster cable (A) to the positive (+) battery terminal of the engine to be started. I 2. Connect the opposite clamp of booster cable (A) to the positive (+) battery terminal of the normal machine. 3.
Connect one clamp of booster cable (B) to the negative (-) battery terminal of the normal ma- chine. 4. Connect the other clamp of booster cable (B) to the engine block of the problem machine. * Make sure the cable clamps are firmly connected to the battery terminals. STARTING ENGINE 1. Start the engine of the normal machine and run the engine above low idle speed. 2. Start the engine of the problem machine as outlined under “STARTING ENGINE”. DISCONNECTING BOOSTER CABLES After the engine has started, disconnect the booster “I” = Engine block of problem machine cables in the reverse order in which they were “II” = Booster batteries connected. “Ill” = Batteries of problem machine 1.
Disconnect the clamp of booster cable (B) from the engine block of the problem machine. 2. Disconnect the other clamp of booster cable (B) from the negative (-) battery terminal of the normal machine. 3. Disconnect the clamp of booster cable (A) from the positive (+) battery terminal of the normal machine. 4. Disconnect the other clamp of booster cable (A) from the positive (+) battery terminal of the problem machine. 2-56