Komatsu — BEFORE CONNECTING BOOSTER CABLES

OPERATION HANDLING OF BATTERY PRECAUTIONS FOR CHARGING BAlTERY 1. Before charging, disconnect the cable from the negative (-) terminal of the battery. Otherwise, an unusually high voltage will damage the alternator. 1) Overheating the battery 2) Decreasing the quantity of electrolyte. 2. While charging the battery, remove all battery caps for satisfactory ventilation. 5. A 3) Damaging the electrode plates. WARNING! To avoid gas explosions, do not bring fire or sparks near the battery. 6. If the electrolyte gets on your skin or clothes, immediately wash with plenty of clean water.

Do not mix up battery cables; positive (+) to negative (-) or negative (-) to positive (+), as this will damage the alternator. If the electrolyte temperature exceeds 45°C (113”F), stop charging for a while. 7. Turn off the charger as soon as the battery is charged. When inspecting or servicing a battery, be sure to stop the engine and turn the starting switch key to “OFF” position. Overcharging the battery may cause the following: 8. When performing any service to battery besides checking the electrolyte level or measuring the specific gravity or voltage reading, disconnect the cables from the battery.

REMOVAL AND INSTALLATION OF BATTERY When removing the battery, first disconnect the l When installing the battery, connect the positive cable from the ground; normally, from the (+) cable first and connect the negative (-) or negative (-) terminal. ground cable to the ground terminal last. A WARNING! If a tool touches a connected positive (+) cable terminal and the chassis, there is danger that it will cause sparks. l Batteries are mounted on both sides of the machine, just in front of the counterweight. The ground cable is connected to the battery, located on the right side. STARTING ENGINE WITH BOOSTER CABLES When starting the engine with booster cables, do as follows: A WARNING!

Be sure to follow all related safety precautions listed in Section 1. BEFORE CONNECTING BOOSTER CABLES 1. The size of the booster cable and clamp should connected. be suitable for the battery size. 4. Keep the starting switch in the “OFF” position. 2. Check booster cables and clamps for damage or corrosion. 5. The battery of the normal machine must be the same capacity as that of the engine to be started. 3. Make sure that the cables and clamps are firmly 2-55