Komatsu — AFTER STORAGE

OPERATION AFTER COLD WEATHER When weather becomes warm, perform the following without fail: l Replace lubricating oils for various units with the ones specified for warm-weather use. LONG TERM STORAGE BEFORE STORAGE To place the machine in storage for an extended l period of time, the following measures must be taken to insure that it can be returned to operation with a minimum of service. 0 Disconnect the negative terminals of the batteries and cover the batteries or remove them from the machine and store them separately. When the ambient temperature is anticipated to drop below 0”, always add antifreeze in the cooling water.

l After every part is washed and dried, the machine shall be housed in a dry building. Never leave it outdoors. 0 If it is unavoidable to leave it outdoors, park the machine on flat ground and cover it with canvas, etc. l Set each control lever to neutral or hold position, lock them and apply the parking brake. Open the air tank drain valves to completely drain the tanks. After draining, close the drain valves. l Completely fill the fuel tank, lubricate and change oil before storage. * If the engine will be out of service longer than six (6) months, take special precautions to prevent rust. Contact the nearest Distributer for information concerning engine storage procedures.

l Apply a thin coat of grease to the metal surfaces of the hydraulic cylinder piston rods and splined shafts. DURING STORAGE A WARNING! If it is unavoidably necessary to l Operate the engine and move the machine for a carry out rust-preventive operation while short distance once a month so the new oil film the machine is indoors, open up doors and will be coated over movable parts and component windows to improve ventilation and prevent surfaces. the gas poisoning. l Before operating the work equipment, wipe off the grease on the hydraulic cylinder piston rods.

AFTER STORAGE NOTICE:lf the machine is stored without carrying out the monthly rust prevention operation, request your distributor for service. l Wipe off the grease on the hydraulic cylinder piston rods. Carry out the following procedure when taking the machine out of long-term storage. l Completely fill the fuel tank, lubricate and add oil. 2-54