OPERATION COLD WEATHER OPERATION PREPARATION FOR LOW TEMPERATURE If the temoerature becomes low, it becomes difficult BAlTERY to start the engine, and the coolant may freeze, so do as follows. l As ambient temperature drops, battery capacity will drop, and electrolyte may sometimes freeze if battery charge is low. Maintain battery at a charge level of approx. 100% and insulate it against cold temperature so that machine can be readily started the next morning. FUEL AND LUBRICANTS Change to fuel and oil with low viscosity for all components. * For details of the specified viscosity, see the TABLE OF FUEL, COOLANT AND LUBRICANTS.
When electrolyte level is low, add distilled water in the morning before work instead of after the day’s work. This is to prevent fluid from freezing at night. COOLANT Use antifreeze during all seasons to protect the A WARNING! To avoid gas explosions, do not bring fire or sparks near the battery. cooling system from-corrosion as well -as freezing damage. WARNING! If the electrolyte gets on your skin or clothes, immediately wash with plenty of clean water. A mixture of 50% water and 50% ethvlene-alvcol base antifreeze is required for operation-of the engine in temperature environments above -37°C. A mixture of 40% water and 60% antifreeze is recommended for temepratures below -37°C.
* Measure specific gravity of fluid and obtain rate of charge from the following conversion table: -1 20°C 0°C -10°C -20°C -30°C 100% 1.28 1.29 1.30 1.31 1.32 90% 1.26 1.27 1.28 1.29 1.30 80% 1.24 1.25 1.26 1.27 1.28 75% 1.23 1.24 1.25 1.26 1.27 CAUTIONS AFTER COMPLETION OF WORK Mud and water on the machine body should be completely removed. Park the machine on concrete or hard ground. If this is impossible, park the machine on wooden boards. This will prevent the accessories from freezing to the ground thereby preventing machine movement the next morning. wiped off because if water is frozen to the rod when the cylinder is utilized, the cylinder oil seals may be damaged. 3.
Drain water collected in fuel system so that such water may be frozen at night. 4. Particular attention should be given to water drops collected on the surface of the hydraulic cylinder piston rods. Such droplets must be fully As battery capacity drops at low ambient temperature, cover the battery or remove it from the machine to be kept warm at night. 2-53