Komatsu — TRANSPORTATION

OPERATION TOWING TOWING THE MACHINE This machine must not be towed except in emergencies. When towing the machine, take the following precautions. A WHEN ENGINE CANNOT BE USED l No lubrication oil flows in the transmission, so disconnect the front and rear drive shafts before moving the machine. WARNING! If there is a failure in the brake line, the brakes cannot be used, so be extremely careful when towing. l The steering cannot be used, so disconnect the steering cylinder and steering linkage. WHEN ENGINE CAN BE USED The machine should be towed only to the nearest place for inspection and maintenance. Do not tow the machine for long distances.

l Always keep the engine running when towing the machine, so that the steering and braking can be used. * TRANSPORTATION When transporting the machine, observe the various road rules, road transportation vehicle limit ordinances, etc. It is a good idea to obtain a special platform for loading and unloading the machine. When it is unavoidably necessary to use a gangplank, however, at the very least observe the following for the sake of safety. A WARNING! Do not on any account change the direction of the machine while it is on the gangplank. To change the direction of the machine, first take -it down from the gangplank. 3. Correctly load the machine onto the specified part of the trailer. 1.

Properly apply the brakes on the trailer and insert blocks beneath the tires to ensure that it does not move. Then fix the gangplank in line with the centers of the trailer and the machine. 4. Lower the bucket and lock each control lever using the safety lock. * Make sure the gangplank has sufficient width, length and thickness to enable the machine to be safety loaded and unloaded. 5. Lock the front and rear frames with the safety bar. 6. When transporting the machine, place blocks underneath the front and rear wheels to prevent the machine from moving about. Also, hold it down with chains or wire ropes. If the gangplank sags appreciably, reinforce it with blocks, etc.

* Determine the route for transporting the machine by taking into account the width, height and weight of the machine. 2. Determine the direction of the gangplank, then slowly load or unload the machine. * When transmission cut-off switch is put in OFF, the left brake pedal and accelerator pedal are operated at the same time. A WARNING! When loading the machine, park the trailer on flat roadbed. Keep a fairly long distance between the road shoulder and the machine. A WARNING! Remove the mud from the undercarriage to prevent the machine from slipping to the side on slopes. 2-52