PERIODIC MAINTENANCE Proper lubrication and maintenance assure trouble-free operation and long machine life. Time and money spent for scheduled periodic maintenance will be amply compensated by prolonged machine operation and reduced operating cost. however, it is recommended to rearrange all of them into units of days, weeks and months, to make the maintenance schedule more convenient. Under rough jobsite or operating conditions, it is necessary to somewhat shorten the maintenance intervals stated in this manual. All hourly figures given in the following descriptions are based on service meter readings. In practice, MAINTENANCE GUIDELINES Perform maintenance work on a hard, flat surface.
Obey precautions: Use genuine parts specified in the Parts Book as replacement parts. During operation, always obey the precautions on the safety product graphics located on the machine. Welding instructions: Use genuine oils and grease. Choose oils and grease with proper viscosities specified for the ambient temperature. l Do not apply more than 200 V continuously. 0 Connect grounding cable within 1 m (3.3 ft) from the area to be welded. 0 Avoid seals or bearings from being between the area to be welded and the position of the grounding point. l Turn off the engine starting switch. Use clean oil and grease. Also, keep containers of the oil and grease clean.
Keep foreign materials away from oil and grease. Always keep the machine clean. This makes is easier to find parts causing problems. Keep in particular grease fiiings, breathers and oil level gauges clean and avoid foreign matters from getting in them. Fire prevention: Use a nonflammable cleaner or light oil for cleaning parts. Keep flame or cigarette light away from cleaning fluid. Be careful of hot coolant and oil: Draining hot oils and coolants and removing their filters immediately after the engine stops are hazardous. Allow the engine to cool. If the oil has to be drained when it is cold, warm up the oil to a suitable temperature (approx. 20”~40°C [68“- 104” F]) before draining it.
Clamping faces: When O-rings or gaskets are removed, clean the clamping faces and replace the O-rings and gaskets with new ones. Be sure to properly fit the O-rings and gaskets when assembling. Objects in your pockets: Keep your pockets free of loose objects which can fall out and drop into the machinery; especially when you work on the machinery while bending over it. Check for foreign materials in drained oil: After oil is changed or filters are replaced, check the oil and filters for metallic particles and foreign materials. If large quantities of metallic particles or foreign materials are found, consult your distributor. l Do not direct a high-pressure jet directly at the radiator.
Fuel strainer: Do not remove the fuel strainer while fueling. Cleaning machine: l Do not splash water on the electrical components. Oil changes: Pre- and post-work checks: Check or change oils in the places where dust is scarce to keep foreign materials away from oils. Before starting work in mud, rain, snow or at the seashore, check plugs and drain valves for tightness. Wash the machine immediately after the work to protect components from rusting. Lubricate components more frequently than usual. Be sure to Warning tag: Attach the warning tag to the starting switch or other appropriate control lever to avoid someone who is not aware of the circumstances from starting the engine. 3-2