Engine Start and Operation 257 The operator should understand the operat- ing characteristics of the engine the vehicle is equipped with. Modern diesel engines have maximum torques at much lower en- gine speeds than in the past. As such, these engines are designed to perform satisfacto- rily at a lower speed. New transmissions with wide ratio steps between gears de- mand the use of these engines. Excessive exhaust smoke may be due to the type of fuel used, a restricted air cleaner, a malfunctioning fuel system or the way the vehicle is operated.
Shift gears and increase or decrease the engine speed as necessary to obtain the engine speed/transmission gear combination which will prevent smok- ing. Excessive smoke indicates wasted fuel which creates carbon deposits in the engine and turbocharger. This causes excessive en- gine wear and oil consumption. Excessive smoke not only pollutes the atmosphere but can also cause shortened exhaust system life. Engine Break-In Engines used in the VN-series are run on dynamometers before being shipped from the manufacturer.
In most applications, the engine can be put to work immediately, but the operator should be extra observant of the operating conditions shown on the gauges during the initial 100 hours or 3000 miles (5000 km). A more frequent check of the engine com- partment for fluid leaks, fluid levels and fastener tightness is also recommended dur- ing the initial period.