BF25D/30D BF25D-BF30D — Sep '94

BF25DoBF30D I tern Thread dia.

x pitch Torque Remark N-m kgf-m Ibfaft Extension caselmount Extension case bolt Lower mount rubber bolt Lower mount housing bolt Upper mount rubber bolt Extension separator bolt Steering friction lever nut M8 x 1.25 M12 x 1.25 M8 x 1.25 M10 x 1.25 M10 x 1.25 M8 x 0.75 22 54 22 44 34 8.5 2.2 5.5 2.2 4.5 3.5 0.85 16 40 16 33 25 6.1 *4 Stern bracket Tilting shaft self-locking nut Stern bracket nut 10 mm self-locking nut Grease nipple 7/8-14 UNF M8 x 1.25 MlOx 1.25 M6 x 1 .O 39 22 34 3 4.0 2.2 3.5 0.3 29 16 25 2.2 *5 Long tiller handle Steering bracket lock nut Steering bracket bolt Long tiller handle nut Under cover screw Connector bracket bolt Emergency stop switch nut Grip pipe bolt Switch bracket bolt Throttle rod lock nut Guide plate bolt M12 x 1.25 M12 x 1.25 M10 x 1.25 M5 x 0.8 M6x 1.0 M16 x 1.0 M6 x 1.0 M6 x 1 .O M6 x 1.0 M6 x 1 .O 54 29 34 2.2 7 1.3 7 4.5 1.3 4.5 5.5 3.0 3.5 0.22 0.7 0.13 0.7 0.45 0.13 0.45 40 22 25 1.6 5.1 0.9 5.1 3.3 0.9 3.3 Gas assisted damper assembly Tilt lever nut M6 x 1 .O 6.5 0.65 4.7 Power tiltltrim assembly Joint metal lock nut Apply thread lock- ing agent.

M14 x 1.5 44 4.5 33 Electrical equipment Neutral switch nut Water hose joint Fastener lever lock nut M20 x 1 .O PT118 M6 x 1 .O 2.5 9 12 0.25 0.9 1.2 1.8 6.5 9 NOTE: *1: Tighten to the specified torque first, then tighten to an additional 90" - 120" . *2: Clean off oil or grease from the flywheel and crankshaft mating surfaces. Apply oil to the seating surface and thread of the nut, and tighten to the specified torque. Then, tighten to an additional 75" - 105" . *3: If the split pin cannot be set by tightening the castle nut to the specified torque, tighten the castle nut addition- ally until the split pin can be set. Maximum torque of the 16 mm castle nut is 34 N*m (3.5 kgf-m, 25 Ibf-ft).

*4: Turn the steering friction lever to the lock position (i.e. fully to the left side where the lever contacts the stop- per). Hold the steering friction lever in this position and tighten the friction lever nut to the specified torque. *5: Tighten the 7/8-14 UNF self-locking nut to the specified torque first, then back it off to 180" - 210". 2-4