BF25D/30D BF25D-BF30D — Sep '94

B F25D-BF30D 2. CARBURETOR CAUTION Running the outboard motor without sufficient cooling water will damage the water pump and overheat the engine. Be sure that water flows from the cooling system indicator while the engine is running. If not, stop the engine and determine the cause of the problem. Idle speed [l] THROTTLE STOP SCREW Specified idle speed (in neutral) 950 f 50 min-1 (rpm) If the idle speed is not stabilized, perform the car- buretor synchronization (see below). After adjustment, adjust the acceleration device/ diaphragm (P. 3-4).

[l] 5 x 10 mm PLUG (3) [2] SEALING WASHER (3) \ / Carburetor Synchronization >AUTION Running the outboard motor without sufficient cooling water will damage the water pump and overheat the engine. Be sure that water flows from the cooling system indicator while the engine is running. If not, stop the engine and determine the cause of the problem. Start the engine and let it run to warm up to normal oper- ating temperature. Stop the engine and perform carbure- tor synchronization. 1) Set the shift lever in the “Neutral” position. 2) Remove the 5 x 10 mm plugs and sealing washers from the intake manifold of each cylinder. 3-2