3) Attach the vacuum gauge adapters to each intake manifold plug hole and connect the vacuum gauge hoses to the adapters. (S.] t11 VACUUM GAUGE ADAPTER, 5 x 0.8 x 120L (3) 0751 0-30001 00 or 5 x 0.8 x 50L (3) 0751 0-3000200 \ Connect: The No.1 vacuum gauge hose to the No.1 vacuum gauge adapter. The No.2 vacuum gauge hose to the No.2 vacuum gauge adapter. The N0.3 vacuum gauge hose to the N0.3 vacuum gauge adapter. VACUUMGAUGE (Commercially available) 4) Start the engine and adjust the idle speed (P. 3-2). 5) Clamp the two SE joint tube 6 using the commercially available tube clips keeping away from the tube pro- tectors as shown.
[2] SE JOINT TUBE B PI TUBE CLIP (Commercially available) [l] TUBE PROTECTOR \ NOTE: Avoid clamping on the tube protectors. Warm up the engine sufficiently before clamping Do not clamp the SE joint tubes with the engine the SE joint tubes. cold, or it will cause poor start of the engine. 6) Check the intake manifold vacuum difference between the cylinders. Take the maximum reading. I Vacuum difference [ 20 mmHg (0.75 inHg) or less [ 7) If the vacuum difference between the cylinders is not 20 mmHg (0.75 inHg) or less, adjust as follows. TOR / [51 161 SE JOINT TUBE 6 TUBE CLIP (Commercially available) 3-3