BF25DeBF30D 8) The N0.3 carburetor is the synchronization base car- buretor. Turn the No.1 and No.2 adjusting screws so that the vacuum difference between each cylinder is 20 mmHg (0.75 inHg) or less. Snap the throttle several times and allow the engine to return to idle. Check to be sure that the vacuum difference between each cylinder stays within 20 mmHg (0.75 inHg) or less. Readjust if necessary. [l] No.1 CARBURETOR ADJUSTING SCREW 9) Stop the engine and remove the two tube clips. 10) Remove the vacuum gauge adapters from the intake manifold, and install the 5 x 10 mm plugs and 5 mm sealing washers. 11) After adjustment, perform idle speed inspection and adjustment (P. 3-2).
[2] No.2 CARBURETOR ADJUSTING SCREW 3. ACCELERATION DEVICE/ DIAPHRAGM Adjustment Adjust the acceleration deviceldiaphragm after adjusting the idle speed. 1) Remove the engine cover. THROTTLE CAM 2) Remove the throttle rod from the throttle cam. 3) Loosen the two 6 x 16 mm torx bit bolts using a com- mercially available torx bit (T30H). [2] DIAPHRAGM 131 6 x 16 mm TORX 6 x 16 mm TORX 4) Disconnect the vacuum tube D from the dashpot check valve. TORX BIT (T30H) (Commercially available) CHECK VALVE IIT (T30H) ,uvm ,,, ,.ercially available)