BF25D/30D BF25D-BF30D — Sep '94

B F25D.B F30D 5) Move the throttle cam slowly in the direction pointed by arrow until the throttle cam roller is set free from the throttle cam, and hold the throttle cam. 6) Move the diaphragm up and down slowly until the clearance between the throttle cam roller and throttle opener cam is 0.2 - 0.8 mm (0.008 - 0.031 in). While holding the clearance, tighten the 6 x 16 mm tom bit bolts to the specified torque using a commer- cially available tom. bit (T30H). TORQUE: 9 N-m (0.9 kgf-m, 6.5 Ibf.ft) After adjustment, attach the throttle rod to the throttle cam. 7 4.

THROTTLE RODRHROlTLE CABLE [l] 6 mm WASHER(2) [2] THROlTLE CABLE Throttle Rod Length Adjustment 1) Remove the 6 mm lock pin and 6 mm washers, and disconnect the thrott\e cable from the throttle arm. I [4] 6.mm LOCK PIN [3] THROTTLE ARM 2) Move the throttle arm to the fully open position and be sure that the throttle arm contacts the fully open stopper. [l] THROTTLE ROLLER [2] 1 mm (0.04 in) or less 3) Check that there is clearance between the throttle cam and throttle roller. Be sure there is clearance of 1 mm (0.04 in) or less between the carburetor throttle lever and stopper on the No.3 carburetor.