BF25D/30D BF25D-BF30D — Sep '94

6 F25D-6 F30D SE (Starter Enrichment) Thermal Valve Take care not to damage the valve part of the SE ther- Adjust the SE thermal valve installation angle as shown mal valve. and tighten the screw securely. Float/Float Valve Removal: 1) Attach a commercially available 2.0 mm pin driver to the opposite side of the knurled section of the float pin as shown. Drive out the float pin by lightly tapping on the 2.0 mm pin driver. €?I 2.0 mm PIN DRIVER (Commercially av 2) Remove the float and float valve. CAUTION Do not damage the installation section of the float pin. [3] KNURLED SECTION [2] FLOAT PIN Installation:

1) Set the float valve on the float tab as shown and install them on the carburetor body. [l] FLOAT TAB 2) Install the float pin in the direction shown. 3) Install the float pin by lightly tapping on the knurled section side of the float pin using a commercially available 2.0 mm pin driver. CAUTION Install the float pin with care not to damage the installation section of the float pin. When the float pin can be installed lightly with hand or when the float pin comes out of posi- tion easily, insert the float pin from the pin installation part of the opposite side and install it with a pin driver.

121 FLOAT V A L ~ E [3] KNURLED SEC ION 2.0 mm PIN DRIVER (Commercially available) [5] FLOAT PIN 5-1 3