BF25D/30D BF25D-BF30D — Sep '94

1 [l] FLOAT VALVE \ B F25DeB F30D b. INSPECTION Float ValveNalve Seat Check the float valve and valve seat for cracks, wear or damage. Replace if necessary. Float Check the float for damage, deformation or gasoline in the float. Replace if necessary. PI PI Replace. OK [4] VALVE SEAT \ [5] FLOAT VALVE Carburetor Float Level Height Measure the float level height with the float installed. Set the float level gauge at right angles to the float chamber mating surface and measure the float level height at the highest place of the float. 11 1 FLOAT LEVEL GAUGE 07401 -001 0000 1) Place the carburetor as shown.

Push the float lightly with a finger and measure the distance between the float top and carburetor body when the float valve just starts to operate. Standard float height BF25D: 14 mm (0.55 in) BF30D: 13 mm (0.51 in) 2) If the height is out of specification, check the float valve and valve seat for wear or damage. 3) If the float valve and float are not worn and damaged, adjust the float height by bending the brass float tab carefully. CAUTION Take care not to damage the float when adjust- ing the float height by bending the float tab. SE (Starter Enrichment) Thermal Valve Check the SE thermal valve and needle for wear or dam- age. Check the O-ring for damage and deterioration.

Replace the O-ring with a new one if necessary. [11 SE THERMAL VALVE 5-1 4